AS5000 Sensor T121406 safety hot tip removers and

safety hot tip removers and holds up to 4 tips with no sleep cable required

Press the button on the pen to create a suction

10 mm × 10 mm) B2410 Φ75mm×2m Duct B2416 Duct Band (2 pcs) B2418 Bench Top Plenum/Clear Parts Required For Independent Ducts

Butterfly louvers enables changes in wind directions

AS5000 Sensor T121406 safety hot tip removers andReplacement for 191 212. 1 piece It is recommended to replace the sensor, AS5000, after 1,500 measurements. However, the timing may vary depending on the tip temperature, solder, and flux. Caution: The sensor is very thin and may break if pressed hard. Measure tip temperature faster and with higher accuracy Approximately 30 times longer than conventional sensors (based on in house tests) Temperature measurement of conventional sensors degrade after 50